DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
39
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DGS-3200-10:4#
3-11 config serial_port
Purpose
Used to configure the serial bit rate that will be used to communicate with the management host and the
auto logout time for idle connections.
Format
config serial_port { baud_rate[9600|19200|38400|115200] |
auto_logout [never|2_minutes|5_minutes|10_minutes|15_minutes] }
Description
The config serial_port command configures the serial bit rate that will be used to communicate with the
management host and the auto logout time for idle connections.
Parameters
Parameters Description
baud_rate
The serial bit rate that will be used to communicate with the management
host. There are four options: 9600, 19200, 38400, and 115200.
auto_logout
The auto logout time out setting :
never
Never timeout.
2_minutes
When you idle over 2 minutes, the device will auto logout.
5_minutes
When you idle over 5 minutes, the device will auto logout.
10_minutes
When you idle over 10 minutes, the device will auto logout.
15_minutes
When you idle over 15 minutes, the device will auto logout.
Restrictions
You must have administrator privileges.
Example
To configure baud rate:
DGS-3200-10:4# config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
To Next Page
Loading...
