D-Link DGS-3200 SERIES - Config Dhcp_Relay Add; Config Dhcp_Relay Delete

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
392
DGS-3200-10:4#config dhcp_relay hops 4 time 2
Command: config dhcp_relay hops 4 time 2
Success.
DGS-3200-10:4#
44-2 config dhcp_relay add
Purpose
Used to add an IP destination address to the switch’s DHCP relay table.
Format
config dhcp_relay add ipif <ipif_name 12> <ipaddr>
Description
The config dhcp_relay add command adds an IP address as a destination to forward (relay)
DHCP/BOOTP packets.
Parameters
Parameters Description
ipif_name
The name of the IP interface which contains the IP address below.
ipaddr
The DHCP/BOOTP server IP address.
Restrictions
You must have administrator privileges.
Examples
To add a DHCP/BOOTP server to the relay table.
DGS-3200-10:4#config dhcp_relay add ipif System 10.43.21.12
Command: config dhcp_relay add ipif System 10.43.21.12
Success.
DGS-3200-10:4#
44-3 config dhcp_relay delete
Purpose
Used to delete one or all IP destination addresses from the switch’s DHCP relay table.