D-Link DGS-3200 SERIES - Reset

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
46
Restrictions
You must have administrator privileges.
Example
DGS-3200-10:4#reboot
Command: reboot
Are you sure to proceed with the system reboot?(y/n)
Please wait, the switch is rebooting…
3-20 reset
Purpose
Used to reset all switch parameters.
Format
reset {[config | system]}
Description
The reset command resets all switch parameters to the factory defaults.
Parameter
Parameters Description
config
If you specify the ‘config’ keyword , all parameters are reset to default
settings. But device will neither save nor reboot.
system
If you specify the ‘system’ keyword, all parameters are reset to default
settings. Then the switch will do factory reset, save, and reboot
If no keyword is specified , all parameters will be reset to default
settings except IP address, user account, and history log. But device
will neither save nor reboot.
Restrictions
You must have administrator privileges.
Example
DGS-3200-10:4#reset
Command: reset
Are you sure to proceed with system reset except IP address?(y/n)
Success.
DGS-3200-10:4#