D-Link DGS-3200 SERIES - Show Snmp Traps

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
80
Description
The show snmp v6host command displays the recipient for which the traps are targeted.
Parameters
Parameters Description
ipaddr
The IP address of the recipient for which the traps are targeted.
If no parameters are specified, all SNMP hosts will be displayed.
v6host
Specifies the v6host IP address.
Restrictions
user level
Example
DGS-3200-10:4# show snmp v6host
Command: show snmp v6host
SNMP Host Table
-------------------------------------------------------------------
Host IPv6 Address: FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
SNMP Version : V3 na/np
Community Name/SNMPv3 User Name: 123456789101234567890
Host IPv6 Address: FECO:1A49:2AA:FF:FE34:CA8F
SNMP Version : V3 a/np
Community Name/SNMPv3 User Name: abcdefghijk
Total Entries : 2
DGS-3200-10:4#
6-19 show snmp traps
Purpose
Used to display the status of SNMP trap and authentication traps.
Format
show snmp traps