xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
198
Figure 5-61 RIP Settings window
The fields that can be configured are described below:
Parameter Description
RIP State
Click the radio buttons to enable or disable RIP globally. The default setting is
Disabled.
Update Time (5-65535)
Enter the value of the rate at which RIP updates are sent.
Timeout Time (5-65535)
Enter the value of the time after which a RIP route is declared to be invalid.
Garbage Collection
Time (5-65535)
Enter the value of the time for which a RIP route will be kept before it is removed
from routing table.
Interface Name
Specifies the IP interface name to display.
Click the Apply button to accept the changes made for each individual section.
Click the Find button to find the specified entry.
Click the View All button to view all the entries.
Click the Edit button to re-configure the selected entry.
After clicking the Edit button, the following window will appear.
Figure 5-62 RIP Settings – Edit window
The fields that can be configured are described below:
Parameter Description
TX Mode Specifies the RIP transmission mode. Options to choose from are v1 Only, v1 Compatible
and v2 Only. Select Disable to disable this option.
RX Mode Specifies the RIP receive mode Options to choose from are v1 Only, v2 Only and v1 or v2.
Select Disable to disable this option.
To Next Page
Loading...
