xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
393
Figure 9-10 DHCP Server Pool Settings Window
The fields that can be configured are described below:
Parameter Description
Pool Name
Enter the DHCP Server Pool name.
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
After clicking the Edit button, the following page will appear:
Figure 9-11 DHCP Server Pool Settings (Edit) Window
The fields that can be configured are described below:
Parameter Description
IP Address
Enter the network address of the pool.
Netmask
Enter the Netmask for the network address.
NetBIOS Node Type
NetBIOS node type for a Microsoft DHCP client.
Domain Name
Domain name of client. The domain name configured here will be used as the default
domain name by the client.
Boot File
File name of boot image. The boot file is used to store the boot image for the client.
The boot image is generally the operating system the client uses to load. If this option
is input twice for the same pool, the second command will overwrite the first
command. If the boot file is not specified, the boot file information will not be provided
to the client.
Next Server
Enter the next server IP address.
DNS Server Address
IP address of DNS server. Specifies the IP address of a DNS server that is available
To Next Page
Loading...
