xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
413
Example
To enable ERPS:
DGS-3620-28SC:admin#enable erps
Command: enable erps
Success.
DGS-3620-28SC:admin#
31-2 disable erps
Description
This command is used to disable the ERPS function on the switch.
Format
disable erps
Parameters
None. The ERPS is disabled by default.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable ERPS:
DGS-3620-28SC:admin#disable erps
Command: disable erps
Success.
DGS-3620-28SC:admin#
31-3 create erps raps_vlan
Description
This command is used to create an R-APS VLAN on the switch. There should be only one R-APS
VLAN used to transfer R-APS messages. Note that the R-APS VLAN must already have been
created by the create vlan command. This command can only be issued when ERPS is disabled.
Format
create erps raps_vlan <vlanid>
To Next Page
Loading...
