D-Link DGS-3620-52P - Page 448

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
443
all - Specify to configure all ports.
state - Specify the port status.
enable - Enable the state.
disable - Disable the state.
illegal_server_log_suppress_duration - Specify the illegal server log suppression duration.
1min - Specify an illegal server log suppression duration of 1 minute.
5min - Specify an illegal server log suppression duration of 5 minutes.
30min - Specify an illegal server log suppression duration of 30 minutes.
trap_log - Specify the trap log status.
enable - Enable the trap log feature.
disable - Disable the trap log feature.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add an entry from the DHCP server/client filter list in the switch’s database:
DGS-3620-28SC:admin#config filter dhcp_server add permit server_ip 10.1.1.1
client_mac 00-00-00-00-00-01 port 1-26
Command: config filter dhcp_server add permit server_ip 10.1.1.1 client_mac 00-
00-00-00-00-01 port 1-26
Success.
DGS-3620-28SC:admin#
To configure the filter DHCP server state:
DGS-3620-28SC:admin#config filter dhcp_server ports 1-10 state enable
Command: config filter dhcp_server ports 1-10 state enable
Success.
DGS-3620-28SC:admin#
35-2 show filter dhcp_server
Description
This command is used to display the DHCP server/client filter list created on the switch.
Format
show filter dhcp_server
Parameters
None.