xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
723
Success.
DGS-3620-28SC:admin#
66-19 config snmp warmstart_traps
Description
This command is used to configure the trap state for warmstart events.
Format
config snmp warmstart_traps [enable | disable]
Parameters
enable - Enable traps for warmstart events. The default state is enabled.
disable - Disable traps for warmstart events.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable traps for warmstart events:
DGS-3620-28SC:admin#config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-3620-28SC:admin#
66-20 config trap source_ipif
Description
This command is used to force change the ipif information in trap messages. By default, trap
messages will carry the information of the ipif they belong to.
Format
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Specify the IP interface name. If only this parameter is specified, the IPv4
address and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specify the IPv4 address.
<ipv6addr> - (Optional) Specify the IPv6 address.
none - Specify to clear the configured source IP interface.
To Next Page
Loading...
