xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
852
System Maximum Address : 512
VLAN Configuration (Only VLANs with limitation are displayed)
VID VLAN Name Max. Learning Addr.
---- -------------------------------- -------------------
1 default 64
2 TstVLAN 8
DGS-3620-28SC:admin#
To display the port security information of switch ports 1 to 6:
DGS-3620-28SC:admin#show port_security ports 1-6
Command: show port_security ports 1-6
Port State Lock Address Mode Max. Learning Addr.
----- ------- ------------------ -----------------
1 Disabled DeleteOnReset 32
2 Disabled DeleteOnReset 32
3 Disabled DeleteOnReset 32
4 Disabled DeleteOnReset 32
5 Disabled DeleteOnReset 32
6 Disabled DeleteOnReset 32
DGS-3620-28SC:admin#
76-8 enable port_security trap_log
Description
This command is used to enable port security traps/logs. When this command is enabled, if there's
a new MAC that violates the pre-defined port security configuration, a trap will be sent out with the
MAC and port information and the relevant information will be logged.
Format
enable port_security trap_log
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable a port security trap:
DGS-3620-28SC:admin#enable port_security trap_log
Command: enable port_security trap_log
To Next Page
Loading...
