D-Link DGS-3620-52P - Page 948

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
943
<candidate_id 1-100> - Specify to add a specific candidate to the group.
<password> - (Optional) Specify the password of a candidate, if necessary.
delete - Specify to remove a specific member from the group.
<member_id 1-32> - Specify to remove a specific member from the group. The ID is from 1 to
32.
Restrictions
Only Administrator-level users can issue this command.
Example
To add a member:
DGS-3620-28SC:admin#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK !!!
SIM Config Success !!!
Success.
DGS-3620-28SC:admin#
To delete a member:
DGS-3620-28SC:admin#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK !!!
SIM Config Success !!!
Success.
DGS-3620-28SC:admin#
88-6 config sim
Description
This command is used to configure the role state and parameters of discovery protocol on the
switch.
Format
config sim [[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-
90> | hold_time <sec 100-255>]
Parameters
commander - Transfer the role to commander.