xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Bandwidth Control
The Bandwidth Control section includes Bandwidth Control Settings and Per Queue Bandwith Control Settings.
Bandwidth Control Settings
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected port.
To view the Bandwidth Control Settings window, click QoS > Bandwidth Control > Bandwidth Control Settings, as shown
below:
Figure 5- 4. Bandwidth Control Settings window
The following parameters can be set or are displayed:
Parameter Description
Unit
Select the unit to configure.
From/To
A consecutive group of ports may be configured starting with the selected port.
Type This drop-down menu allows you to select between RX (receive), TX (transmit), and
Both. This setting will determine whether the bandwidth ceiling is applied to receiving,
transmitting, or both receiving and transmitting packets.
No Limit This drop-down menu allows you to specify that the selected port will have no bandwidth
limit. Enabled disables the limit or limits the bandwidth on a given port.
Rate (64-
10000000)
This field allows the user to enter the data rate that will be the limit for the selected port.
A rate can only be entered if the No Limit feature is Disabled.
Click Apply to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be displayed in the
Port Bandwidth Table.
300
To Next Page
Loading...
Need help?
General