DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
304
The fields that can be configured in Register Keepalive Time are described below:
Parameter Description
Register Keepalive
Enter the register keep-alive time value here. The range from 1 to 65525 seconds.
Select the Default option to use the default value, which is 185 seconds.
Click the Apply button to accept the changes made.
After clicking the Show List button, the following page will appear.
Figure 6-125 PIM Register Settings (Show List) Window
The fields that can be configured are described below:
Parameter Description
ACL Type
Select the ACL type that will be used to display the type of existing access lists in
the table here. Options to choose from are IP ACL, Expert IP ACL, IPv6 ACL,
Expert IPv6 ACL, MAC ACL, and Expert ACL.
ACL List
Select the radio button of the access list in the table that will be used here.
Click the Find button to display a list of access lists based on the selection made.
Click the Show All button to display all configured access lists.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Apply button to use the selected access list.
PIM SPT Threshold Settings
This window is used to display and configure the PIM SPT threshold settings. Use this feature on the last hop of the
router. In the PIM-SM mode, initially the multicast traffic from the source will be flowing along the RPT share tree to
the receiver. After the first packet arrives at the last hop router, for each group of traffic, it can operate in one of the
following two modes. With the mode Infinity, the traffic keeps following the share tree. With the mode 0, the source
tree will be established and the traffic Switchover to the source tree.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM SPT
Threshold Settings, as shown below:
Figure 6-126 PIM SPT Threshold Settings Window
To Next Page
Loading...
