1040658-0001 Revision B December 8, 2015
Installing Your D-Link Wireless Router
In the box
Ensure the box contains the following items. See Figure 1.
D-Link Wireless N300 Cloud Router, DIR-619L
Power supply, 12V/1A
Ethernet cable
Figure 1: Kit contents
If you do not subscribe to HughesNet Voice, follow the
instructions in Installing the router without HughesNet Voice on
panel 2.
If you do subscribe to HughesNet Voice, follow the instructions in
Installing the router with HughesNet Voice on panel 4.
Installing the router without
HughesNet Voice
Only follow the steps in this section if you do not subscribe to
HughesNet Voice.
When you have completed the steps in this section, your
connections will be the same as those shown in Figure 2. Refer to
the figure when performing the steps.
Figure 2: Wireless router connections without Voice
Installing the router without
HughesNet Voice (cont.)
1. Ensure there is nothing plugged into the LAN port on your
HughesNet modem (such as your laptop or PC). If there is,
remove it.
Leave the other modem cable connections as they are.
2. Connect the blue Ethernet cable provided in the kit to the LAN
port on your modem.
3. Connect the other end of the blue Ethernet cable to the
yellow LAN port on the D-Link wireless router.
4. Connect the power supply provided in the kit to the wireless
router.
5. Plug the power supply into an electrical outlet or surge
protector.
6. [Optional] Using an Ethernet cable, connect your laptop or PC
to a LAN port on the wireless router. This provides a direct,
wired connection to the network.
7. Ensure all of your connections match those shown in Figure 2.
8. Verify the power light on the wireless router is lit. See
Figure 3.
9. Wait 2 minutes, then check that the power, Internet, and Wi-
Fi signal lights on the top of the router are lit. If anything is
plugged into the router LAN ports, those lights will also
illuminate. See Figure 3.
Figure 3: Router LEDs
10. Proceed to Logging into your new wireless network on
panel 6.
Installing the router with
HughesNet Voice
Only follow the steps in this section if you subscribe to
HughesNet Voice.
When you have completed the steps in this section, your
connections will be the same as those shown in Figure 4. Refer to
the figure when performing the steps.
Figure 4: Wireless router connections with Voice
To Next Page
Need help?
General
