D-Link DSR-1000 - Page 243

243
付録D ログメッセージ
ログメッセージ 緊急度 ログメッセージ 緊急度
version DEBUG IPT_ACCOUNT_NAME : checkentry() wrong parameters (not
equals existing table parameters).
INFO
o󱐯set_before=%d, o󱐯set_after=%d, correction_pos=%u,
x->o󱐯set_before, x- >o󱐯set_after, x->correction_pos
DEBUG IPT_ACCOUNT_NAME : checkentry() too big netmask. INFO
ip_ct_h323: DEBUG IPT_ACCOUNT_NAME : checkentry() failed to allocate %zu
for new table %s., sizeof(struct t_ipt_account_table), info-
>name
INFO
ip_ct_h323: incomplete TPKT (fragmented?) DEBUG IPT_ACCOUNT_NAME : checkentry() wrong network/
netmask.
INFO
ip_ct_h245: decoding error: %s, DEBUG account: Wrong netmask given by netmask parameter (%i).
Valid is 32 to 0., netmask
INFO
ip_ct_h245: packet dropped DEBUG IPT_ACCOUNT_NAME : checkentry() failed to create procfs
entry.
INFO
ip_ct_q931: decoding error: %s, DEBUG IPT_ACCOUNT_NAME : checkentry() failed to register match. INFO
ip_ct_q931: packet dropped DEBUG failed to create procfs entry . INFO
ip_ct_ras: decoding error: %s, DEBUG MPPE/MPPC encryption/compression module registered INFO
ip_ct_ras: packet dropped DEBUG MPPE/MPPC encryption/compression module unregistered INFO
ERROR registering port %d, DEBUG PPP generic driver version PPP_VERSION INFO
ERROR registering port %d, DEBUG MPPE/MPPC encryption/compression module registered INFO
ipt_connlimit [%d]: src=%u.%u.%u.%u:%d
dst=%u.%u.%u.%u:%d %s,
DEBUG MPPE/MPPC encryption/compression module unregistered INFO
ipt_connlimit [%d]: src=%u.%u.%u.%u:%d
dst=%u.%u.%u.%u:%d new,
DEBUG PPP generic driver version PPP_VERSION INFO
ipt_connlimit: Oops: invalid ct state ? DEBUG PPPoL2TP kernel driver, %s, INFO
ipt_connlimit: Hmm, kmalloc failed :-( DEBUG PPPoL2TP kernel driver, %s, INFO
ipt_connlimit: src=%u.%u.%u.%u mask=%u.%u.%u.%u DEBUG PPPoL2TP kernel driver, %s, INFO
_lvl PPPOL2TP: _fmt, ##args DEBUG failed to create procfs entry . INFO
%02X, ptr[length] DEBUG proc dir not created .. INFO
%02X, ((unsigned char *) m- >msg_iov[i].iov_base)[j] DEBUG Initialzing Product Data modules INFO
%02X, skb->data[i] DEBUG De initializing by \ INFO
_lvl PPPOL2TP: _fmt, ##args DEBUG kernel UMI module loaded INFO
%02X, ptr[length] DEBUG kernel UMI module unloaded INFO
%02X, ((unsigned char *) m- >msg_iov[i].iov_base)[j] DEBUG Loading bridge module INFO
%02X, skb->data[i] DEBUG Unloading bridge module INFO
_lvl PPPOL2TP: _fmt, ##args DEBUG unsupported command %d, cmd INFO
%02X, ptr[length] DEBUG Loading ifDev module INFO
%02X, ((unsigned char *) m- >msg_iov[i].iov_base)[j] DEBUG Unloading ifDev module INFO
%02X, skb->data[i] DEBUG ERROR#%d in alloc_chrdev_region, result INFO
KERN_EMERG THE value read is %d,value*/ DEBUG ERROR#%d in cdev_add, result INFO
KERN_EMERG Factory Reset button is pressed DEBUG using bcm switch %s, bcmswitch INFO
KERN_EMERG Returing error in INTR registration DEBUG
privlegedID %d wanporttNo: %d, privlegedID,wanportNo INFO
KERN_EMERG Initialzing Factory defaults modules DEBUG Loading mii INFO
Failed to allocate memory for pSipListNode DEBUG Unloading mii INFO
SIPALG: Memeory allocation failed for pSipNodeEntryTbl DEBUG %s: Version 0.1 INFO
pkt-err %s, pktInfo.error DEBUG %s: driver unloaded, dev_info INFO
pkt-err %s, pktInfo.error DEBUG wlan: %s backend registered, be- >iab_name INFO
pkt-err %s, pktInfo.error DEBUG wlan: %s backend unregistered, INFO
%s Len=%d, msg, len DEBUG wlan: %s acl policy registered, iac- >iac_name INFO
%02x , ((uint8_t *) ptr)[i] DEBUG wlan: %s acl policy unregistered, iac- >iac_name INFO
End DEBUG %s, tmpbuf INFO
CVM_MOD_EXP_BASE MISMATCH cmd=%x base=%x, cmd, DEBUG VLAN2 INFO
op->sizeofptr = %ld, op->sizeofptr DEBUG VLAN3 INFO
opcode cmd = %x, cmd DEBUG VLAN4 <%d %d>, INFO
modexp opcode received DEBUG %s: %s, dev_info, version INFO