Unified Services Router User Manual
232
Enabling remote access management
for IP address range"
Disabling Port Trigger Rule for
%d:%d:%d:%d:%d
Enabling remote access management to
only this PC.
Adding Port Trigger Rule for
%d:%d:%d:%d:%d
Disabling Management Access from
Disabling remote access management
Disabling remote access management
only to this PC.
MAC Filtering %sabled for BLOCK and
PERMIT REST.
Setting NAT mode for pLogicalIfName
= %s
MAC Filtering %sabled for PERMIT and
BLOCK REST.
Enabling Content Filtering.
Enabling DROP for FORWARD
Disabling Content Filtering.
Enabling NAT based Firewall Rules
Deleting rule, port triggering for protocol
TCP.
Setting transparent mode for
pLogicalIfName \
Deleting rule, port triggering for protocol
UDP.
Enabling Accept for INPUT
Deleting rule, port triggering for protocol
TCP.
Enabling Accept for FORWARD
Deleting rule, port triggering for protocol
Setting Routing mode for
Enabling rule, port triggering for protocol
Enabling rule, port triggering for protocol
UDP.
Enabling DROP for FORWARD
Enabling rule, port triggering for protocol
TCP.
Disabling NAT based Firewall Rules
Enabling rule, port triggering for protocol
UDP.
Enabling Firewall Rules for URL
Filtering & "
Adding Firewall Rule for RIP Protocol
Restarting Schedule Based Firewall
checking DNS proxy for Secure zone.
enabling IPS checks between %s and
%s zones.
checking DNS proxy for Public zone.
disabling IPS checks between %s and
%s zones.
Enabling Block traffic from %s zone.
Configuring firewall session settings for "
Disabling WAN-DMZ rules .
Route addition failed: Network
Unreachable
Route addition failed: Network is down
Restarting DMZ rule having %s address
Failed to add rule in iptables
OneToOneNat configured successfully
Failed to delete rule from iptables
OneToOneNat configuration failed
fwLBSpillOverConfigure: Something
going wrong here
Deleting scheduled IPv6 rules.
fwLBSpillOverConfigure: unable to get
delete from FirewallRules6 where
fwLBSpillOverConfigure: Could not set