Unified Services Router User Manual
186
pnacRadXlateRadPktIntegrityChk: no
corresponding "
pnacPortPaeDeconfig:kpnacPortPaeDec
onfig failed
Error from
pnacRadXlateRadPktIntegrityChk: no
message "
pnacPortPaeDeconfig:kpnacPortPaeDec
onfig failed
Error from
pnacRadXlateRadPktIntegrityChk: "
pnacBackAuthSuccess: failed to notify
the destination "
From
pnacRadXlateRadChalPktHandle: no
encapsulated eap "
could not initialize MGMT framework
Error from
pnacRadXlateRadChalPktHandle:
malloc for eap "
Error from
pnacEapDemoSuppUserInfoRegister:
invalid "
Error from pnacEapDemoSuppRecv:
received null EAP pkt
could not initialize IAPP MGMT.
Error from pnacEapDemoSuppRecv:
send ptr to pnac supplicant"
From pnacEapDemoSuppRecv: user
info not entered yet
buffer length not specified
Error from pnacEapDemoSuppRecv:
couldn't "
Invalid length(%d) specified
MDString: adpDigestInit for md5 failed
Failed to get information about
authorized AP list.
pnacUmiInit: UMI initialization failed
Recd IE data for non-existent AP %s
could not start PNAC task
Recd IE data for wrong AP %s
Received Invalid IE data from WSC
Recd IE data for non-existent AP %s
pnacPhyPortParamSet: device invalid
%s%d
Recd WSC Start command without
interface name
pnacPhyPortParamSet: EIOCGADDR
ioctl failed
Recd WSC start for non-existent AP %s
pnacPhyPortParamSet: multicast addr
add ioctl failed
Recd WSC start for wrong AP %s
pnacPhyPortParamUnset: multicast
addr del ioctl failed
Unable to send
WSC_WLAN_CMD_PORT to WSC
pnacPDUXmit: Invalid arguments
Failed to get the ap context for %s
pnacPDUXmit: failed to get M_BLK_ID
WPS can only be applied to WPA/WPA2
security profiles
from pnacIsInterfaceUp: device %s%d
invalid
wpsEnable: running wsccmd failed
pnacRecvRtn: dropping received
packet as port is"
Failed to get the ap context for %s
pnacSendRtn: Invalid arguments
WPS conf. under non WPA/WPA2
security setting
pnacSendRtn: no physical port
corresponding to"
Failed to reset the Beacon Frame IE in
the driver
pnacSendRtn: dropping packet as
port"
Failed to reset the Beacon Frame IE in
the driver
pnacAuthBuildRC4KeyDesc:
adpEncryptInit(RC4) failed
WPS method cannot be NULL
pnacAuthBuildRC4KeyDesc:
adpCipherContextCtrl"
PIN value length should be a multiple of
4 !!
pnacDot11UserSet: incorrect buffer
length
Failed to initiate PIN based association,
PIN = %s
PNAC user component id not set.