D-Link DWS-3160-24TC - Cfm Loopback Settings; Cfm Mipccm Table; Cfm Port Settings

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
282
CFM Port Settings
This window is used to enable or disable the CFM function on a per-port basis.
To view this window, click OAM > CFM > CFM Port Settings, as shown below:
Figure 13-10 CFM Port Settings Window
The fields that can be configured are described below:
Parameter Description
From Port / To Port
Use the drop-down menus to select a range of ports to be configuration.
State
Use the drop-down menu to enable or disable the state of specific port regarding the
CFM configuration.
Click the Apply button to accept the changes made.
CFM MIPCCM Table
This window is used to show the MIP CCM database entries.
To view this window, click OAM > CFM > CFM MIPCCM Table, as shown below:
Figure 13-11 CFM MIPCCM Table Window
CFM Loopback Settings
This window is used to start a CFM loopback test.
To view this window, click OAM > CFM > CFM Loopback Settings, as shown below: