DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
336
Total Number of
Discovered-Filed
Display the amount of devices that have an IP address configured in the IP
Discovery list that the switch has attempted to contact and failed to authenticate or
Total number of entries displayed in the table below.
Display the IP address of the device configured in the IP Discovery list.
Status
The status is in one of the following states:
• Not Polled – The switch has not attempted to contact the IP address in the
L3/IP Discovery list.
• Polled – The switch has attempted to contact the IP address.
• Discovered – The switch contacted the peer switch or the AP in the L3/IP
Discovery list and has authenticated or validated the device.
• Discovered – Failed – The switch contacted the peer switch or the AP with IP
address in the L3/IP Discovery list and was unable to authenticate or validate
the device.
If the device is an access point, an entry appears in the AP failure list with a failure
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Configuration Received tab, the following page will appear:
Figure 2-4 Configuration Received window
The fields that can be displayed are described below:
Parameter Description
Current Receive Status
Display the global status when wireless configuration is received from a peer
switch. The possible status values are Not Started, Receiving Configuration,
Saving Configuration, Applying AP Profile Configuration, Success, Failure - Invalid
Code Version, Failure - Invalid Hardware Version, and Failure - Invalid
Peer Switch IP Address
Display the last switch from which this switch received any wireless configuration
Configuration
Display which portions of configuration were last received from a peer switch,
which can be one or more of the following:
To Next Page
Loading...
