D-Link DWS-3160-24TC - Page 165

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
161
DWS-3160-24PC:admin#config captive_portal http_port 100
Command: config captive_portal http_port 100
Success.
DWS-3160-24PC:admin#
To disable the Captive Portal’s statistics report option:
DWS-3160-24PC:admin#config captive_portal statistics_interval 0
Command: config captive_portal statistics_interval 0
Success.
DWS-3160-24PC:admin#
To configure the Captive Portal’s authentication timeout value:
DWS-3160-24PC:admin#config captive_portal authentication_timeout 600
Command: config captive_portal authentication_timeout 600
Success.
DWS-3160-24PC:admin#
15-4 config captive_portal trap
Description
This command is used to enable or disable Captive Portal SNMP traps.
Format
config captive_portal trap [enable | disable] [all | client_auth_failure | client_connect |
client_disconnect | client_db_full]
Parameters
enable - Specifies that the Captive Portal trap option will be enabled.
disable - Specifies that the Captive Portal trap option will be disabled.
all - Specifies that all trap, concerning the Captive Portal, will be sent.
client_auth_failure - Specifies that a trap will be sent when a client attempts to authenticate with
a Captive Portal but is unsuccessful.
client_connect - Specifies that a trap will be sent when a client authenticates with and connects
to a Captive Portal.
client_disconnect - Specifies that a trap will be sent when a client disconnects from a Captive
Portal.
client_db_full - Specifies that a trap will be sent each time an entry cannot be added to the client
database because it is full.
Restrictions
Only Administrators can issue this command.