D-Link DWS-3160-24TC - Page 174

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
170
name - Specifies the name for the Captive Portal configuration.
<name 32> - Enter the Captive Portal configuration name used here. This name can be up to
32 characters long.
default - Specifies that the default value will be used.
protocol - Specifies the protocol used for the Captive Portal configuration. The Captive Portal
can use either HTTP or HTTPS protocols.
http - Specifies that the protocol used, for the Captive Portal configuration, is HTTP. This is
the default option.
https - Specifies that the protocol used, for the Captive Portal configuration, is HTTPS.
redirect - Specifies to enable or disable the redirect mode for the Captive Portal configuration.
enable - Specifies that the redirect mode, for the Captive Portal configuration, will be enabled.
disable - Specifies that the redirect mode, for the Captive Portal configuration, will be
disabled. This is the default option.
redirect_url - Specifies the URL that the newly authenticated client will be redirected to, if the
URL Redirect Mode is enabled.
<string 255> - Enter the redirect URL string used here. This string can be up to 255
characters long.
separator_color - Specifies to customize the separator bar color of the Captive Portal
authentication page.
<string 32> - Enter the separator bar's color value used here. This value can be up to 32
characters long. The default value is #326BA0.
default - Specifies that the default value will be used.
session_timeout - Specifies the session timeout for the Captive Portal configuration.
<int 0-86400> - Enter the session timeout value used here. This value must be between 0 and
86400 seconds. The value of 0, indicates that no timeout will be enforced. The default
value is 86400.
default - Specifies that the default value will be used.
user_logout - Specifies to enable or disable the ability for an authenticated user to de-
authenticate from the network.
enable - Specifies that an authenticated user will have the ability to de-authenticate from the
network.
disable - Specifies that an authenticated user will not have the ability to de-authenticate from
the network.
verification - Specifies the verification mode for a Captive Portal configuration.
guest - Specifies that the user does not need to be authenticated using a database. This is
the default option.
local - Specifies that the Switch will use the local database to authenticate users.
radius - Specifies that the Switch will use a database on a remote RADIUS server to
authenticate users.
Restrictions
Only Administrators can issue this command.
Example
To disable the Captive Portal configuration 1:
DWS-3160-24PC:admin#config captive_portal configuration 1 state disable
Command: config captive_portal configuration 1 state disable
Success.
DWS-3160-24PC:admin#
To configure the Captive Portal configuration to the default values: