D-Link DWS-3160-24TC - Config Authentication Server Failover; Show Authentication

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
203
Restrictions
None.
Example
To display the authorization status:
DWS-3160-24PC:admin#show authorization
Command: show authorization
Authorization for Attributes: Enabled
DWS-3160-24PC:admin#
17-10 config authentication server failover
Description
This command is used to configure authentication server failover function.
Format
config authentication server failover [local | permit | block]
Parameters
local - Use local DB to authenticate the client.
permit - The client is always regarded as authenticated.
block - Block the client (Default setting).
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the authentication server’s failover state:
DWS-3160-24PC:admin# config authentication server failover local
Command: config authentication server failover local
Success.
DWS-3160-24PC:admin#
17-11 show authentication
Description
This command is used to display the global authentication configuration.