D-Link DWS-3160-24TC - Page 23

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
19
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To display the greeting message:
DWS-3160-24PC:admin#show greeting_message
Command: show greeting_message
==============================================================================
DWS-3160-24PC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.034
Copyright(C) 2012 D-Link Corporation. All rights reserved.
==============================================================================
DWS-3160-24PC:admin#
2-14 config command_prompt
Description
This command is used to modify the command prompt in the CLI interface. It will modify the first
part with a string consisting of a maximum of 16 characters, or to be replaced with the users’ login
user name. When users issue the ‘reset’ command, the current command prompt will remain intact.
Yet, issuing the ‘reset system’ will return the command prompt to its original factory default value.
Format
config command_prompt [<string 16> | username | default]
Parameters
<string 16> - Enter the new command prompt string of no more than 16 characters.
username - Specifies to configure the login username as the command prompt.
default – Specifies to return the command prompt to its original factory default value.
Restrictions
Only Administrators and Operators can issue this command.