D-Link DWS-3160-24TC - Page 287

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
283
Format
show dhcp_relay option_60 {[string <multiword 255> | ipaddress <ipaddr> | default]}
Parameters
string - (Optional) Display the entry which’s string equal the string of specified.
<multiword 255> - Enter the entry's string value here. This value can be up to 255 characters
long.
ipaddress - (Optional) Display the entry whose IP address equal the specified ipaddress.
<ipaddr> - Enter the IP address here.
default - (Optional) Display the default behavior of DHCP relay Option 60.
If no parameter is specified then all the DHCP Option 60 entries will be displayed.
Restrictions
None.
Example
To display DHCP Option 60 information:
DWS-3160-24PC:admin#show dhcp_relay option_60
Command: show dhcp_relay option_60
Default Processing Mode: Drop
Default Servers:
Matching Rules:
String Match Type IP Address
------- --------- ---------
abc Exact Match 10.90.90.1
Total Entries : 1
DWS-3160-24PC:admin#
24-16 config dhcp_relay option_61
Description
This command is use to decide whether the DHCP relay will process the DHCP Option 61 or not.
When Option 61 is enabled, if the packet does not have Option 61, then the relay servers cannot
be determined based on Option 61.
If the relay servers are determined based on Option 60 or Option 61, then per IPIF configured
servers will be ignored.
If the relay servers are not determined either by Option 60 or Option 61, then per IPIF configured
servers will be used to determine the relay servers.