D-Link DWS-3160-24TC - Config Gvrp

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
35
3-14 show pvid auto_assign
Description
This command is used to display the PVID auto-assignment state.
Format
show pvid auto_assign
Parameters
None.
Restrictions
None.
Example
To display PVID auto-assignment state:
DWS-3160-24PC:admin#show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled
DWS-3160-24PC:admin#
3-15 config gvrp
Description
The command is used to configure the Generic VLAN Registration Protocol (GVRP) timer value.
Format
config gvrp [timer {join <value 100-100000> | leave <value 100-100000> | leaveall <value 100-
100000> } | nni_bpdu_addr [dot1d | dot1ad]]
Parameters
timer - Specifies that the GVRP timer parameter will be configured.
join
- (Optional) Specifies the Join time will be set.
<value 100-100000> - Enter the join time used here. This value must be between 100 and
100000. The default value is 200 milliseconds.
leave - (Optional) Specifies the Leave time will be set.
<value 100-100000> - Enter the leave time used here. This value must be between 100 and
100000. The default value is 600 milliseconds.
leaveall - (Optional) Specifies the LeaveAll time will be set.
<value 100-100000> - Enter the leave all time used here. This value must be between 100
and 100000. The default value is 10000 milliseconds.
nni_bpdu_addr - Used to determine the BPDU protocol address for GVRP in service provide