D-Link DWS-3160-24TC - Page 532

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
528
Parameters
ports - (Optional) Specifies the range of ports that will display their configuration. While this
parameter is null, to display the entries on all of the ports.
<portlist> - Enter the list of port used for this configuration here.
vlan
- (Optional) Specifies the name of the VLAN that will display its configuration.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Specifies the ID of the VLAN that will display its configuration.
<vidlist> - Enter the VLAN ID list here.
Restrictions
None.
Example
To display the global configuration of port security:
DWS-3160-24PC:admin#show port_security
Command: show port_security
Port Security Trap/Log : Disabled
System Maximum Address : 256
VLAN Configuration (Only VLANs with limitation are displayed)
VID VLAN Name Max. Learning Addr.
---- -------------------------------- ------------------
1 default 64
DWS-3160-24PC:admin#
54-8 enable port_security trap_log
Description
This command is used to enable the port security trap/log. When the port security trap is enabled,
if there is a new MAC address that violates the pre-defined port security configuration, a trap will
be sent out with the MAC address, port and other relevant information being logged.
Format
enable port_security trap_log
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.