D-Link DXS-3326GSR - Page 109

DXS-3326GSR Gigabit Layer 3 Switch
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch
will examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the
Switch will use to determine what to do with the frame. The entire process is described below in two parts.
To display the currently configured Access Profiles on the Switch, open the Configuration folder and click on the Access
Profile Table link. This will open the Access Profile Table window (the example shown below includes one of each type
that have already been configured by clicking Add and then choosing the desired Type from the drop-down menu on the
Access Profile Configuration window).
Figure 6- 53. Access Profile Table window
To add an entry to the Access Profile Table window, click the Add button. This will open the Access Profile
Configuration window, as shown below. There are three Access Profile Configuration windows; one for Ethernet (or
MAC address-based) profile configuration, one for IP address-based profile configuration, and one for the Packet Content
Mask. You can switch among the three Access Profile Configuration windows by using the Type drop-down menu. The
window shown below is the Access Profile Configuration window for Ethernet.
Figure 6- 54. Access Profile Table (Ethernet) window
The following parameters can be set, for the Ethernet type:
Parameter Description
Profile ID (1-8)
Type in a unique identifier number for this profile set. This value can be set from 1 to
8.
Type
Select profile based on Ethernet (MAC Address), IP address or packet content mask.
This will change the window according to the requirements for the type of profile.
• Select Ethernet to instruct the Switch to examine the la
y
er 2
p
art of each
96