DXS-3326GSR Gigabit Layer 3 Switch
Routing information source − OSPF and the Static Route table. Routing information will be redistributed to RIP. The
following table lists the allowed values for the routing metrics and the types (or forms) of the routing information that will
be redistributed.
Route Source Metric Type
OSPF 0 to 16 All Internal External
ExtType1 ExtType2
Inter-E1 Inter-E2
RIP 0 to 16777214 Type 1 Type 2
Static 0 to 16777214 Type 1 Type 2
Local 0 to 16777214 Type 1 Type 2
Table 7- 3. Route Redistribution Source table
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1
type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
This window will redistribute routing information between the OSPF and RIP routing protocols to all routers on the
network that are running OSPF or RIP. To access the Route Redistribution Settings window, go to Configuration >
Layer 3 IP Networking > Route Redistribution Settings:
Figure 7- 6. Route Redistribution Settings window
The following parameters may be set or viewed:
Parameter Description
Dest Protocol
Allows for the selection of the protocol for the destination device. Choose between RIP
and OSPF.
Src Protocol
Allows for the selection of the protocol for the source device. Choose between RIP,
OSPF, Static and Local.
Type
Allows for the selection of one of six methods of calculating the metric value. The user
may choose between All, Internal, External, ExtType1, ExtType2, Inter-E1, Inter-E2.
See the table above for available metric value types for each source protocol.
Metric (0-16)
Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the
RIP routing protocol.
Click Add/Modify to implement changes made.
126
To Next Page
Loading...
