DXS-3326GSR Gigabit Layer 3 Switch
NOTE: The user must configure Authentication Server Hosts using the
Authentication Server Hosts window before adding hosts to the list.
Authentication Server Hosts must be configured for their specific protocol
on a remote centralized server before this function can work properly.
NOTE: These three built-in server groups can only have server hosts
running the same TACACS daemon. TACACS/XTACACS/TACACS+
protocols are separate entities and are not compatible with each other.
Authentication Server Host
This window will set user-defined Authentication Server Hosts for the TACACS/XTACACS/TACACS+/RADIUS
security protocols on the Switch. When a user attempts to access the Switch with Authentication Policy enabled, the
Switch will send authentication packets to a remote TACACS/XTACACS/TACACS+/RADIUS server host on a remote
host. The TACACS/XTACACS/TACACS+/RADIUS server host will then verify or deny the request and return the
appropriate message to the Switch. More than one authentication protocol can be run on the same physical server host but,
remember that TACACS/XTACACS/TACACS+/RADIUS are separate entities and are not compatible with each other.
The maximum supported number of server hosts is 16.
To view the following window, click Security Management > Access Authentication Control > Authentication Server
Host:
Figure 8- 10. Authentication Server Host Settings window
To add an Authentication Server Host, click the Add button, revealing the following window:
Figure 8- 11. Authentication Server Host Setting – Add window
Configure the following parameters to add an Authentication Server Host:
177
To Next Page
Loading...
