D-Link DXS-3326GSR - SNMP Host Table

DXS-3326GSR Gigabit Layer 3 Switch
managers access to MIB objects in the Switch's SNMP agent.
View Name
Type an alphanumeric string of up to 32 characters that is used to identify the group
of MIB objects that a remote SNMP manager is allowed to access on the Switch. The
view name must exist in the SNMP View Table.
Access Right
Read_Only - Specifies that SNMP community members using the community string
created can only read the contents of the MIBs on the Switch.
Read_Write - Specifies that SNMP community members using the community string
created can read from, and write to the contents of the MIBs on the Switch.
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the under
the Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder and click on the SNMP Host Table link. This will open the SNMP Host Table
window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP
Address heading.
Figure 9- 10. SNMP Host Table window
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window.
This will open the SNMP Host Table Configuration window, as shown below.
The following parameters can set:
Parameter Description
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
Figure 9- 11. SNMP Host Table Configuration window
Host IP Address
199