DXS-3326GSR Gigabit Layer 3 Switch
Figure 4- 2. Command Prompt
NOTE: The first user automatically gets Administrator level privileges. It is
recommended to create at least one Admin-level user account for the
Switch.
Password Protection
The DXS-3326GSR does not have a default user name and password. One of the first tasks when settings up the Switch is
to create user accounts. If you log in using a predefined administrator-level user name, you have privileged access to the
Switch's management software.
After your initial login, define new passwords for both default user names to prevent unauthorized access to the Switch,
and record the passwords for future reference.
To create an administrator-level account for the Switch, do the following:
At the CLI login prompt, enter create account admin followed by the <user name> and press the Enter key. •
•
•
•
You will be asked to provide a password. Type the <password> used for the administrator account being
created and press the Enter key.
You will be prompted to enter the same password again to verify it. Type the same password and press the Enter
key.
Successful creation of the new administrator account will be verified by a Success message.
NOTE: Passwords are case sensitive. User names and passwords can be
up to 15 characters in length.
The sample below illustrates a successful creation of a new administrator-level account with the user name "newmanager".
DXS-3326GSR:4#create account admin newmanager
Command: create account admin newmanager
25
To Next Page
Loading...
