D-Link DXS-3326GSR - LACP Port Setting

DXS-3326GSR Gigabit Layer 3 Switch
Master Port
Choose the Master Port for the trunk group using the pull-down menu.
Unit
Choose the Unit for the trunk group using the pull-down menu.
Member Ports
Choose the members of a trunked group. Up to 8 ports per group can be assigned
to a group.
Flooding Port
A trunking group must designate one port to allow transmission of broadcasts and
unknown unicasts.
After setting the previous parameters, click Apply to allow your changes to be implemented. Successfully created trunk
groups will be shown in the Current Link Aggregation Group Entries window.
LACP Port Setting
The LACP Port Setting window is used in conjunction with the Link Aggregation window to create port trunking groups
on the Switch. Using the following window, the user may set which ports will be active and passive in processing and
sending LACP control frames.
45