DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
173
Parameter Description
multicast VLAN, but does not match the associated profile, then the packet will be
forwarded or dropped based on this setting. By default, the packet will be
dropped.
Multicast VLAN IPv6 State
Select to enable or disable the IPv6 IGMP control packet process in multicast
VLANs.
Ignore VLAN
Select the enable or disable the ignore VLAN feature here. This specifies the
setting for tagged IGMP or MLD control packets. If enabled, then the packet’s
VLAN is ignored and taken to match the profile to find its multicast VLAN. When
this option is enabled, the Switch will ignore the VLAN of the receiving IGMP or
MLD control packet and try to find a match profile.
VID
Enter the VLAN ID of the multicast VLAN that will be created or deleted here. The
range is 2 to 4094.
VLAN Name
Enter the VLAN name of the multicast VLAN that will be created or deleted here.
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
Click the Add button to add a new entry based on the information entered.
The fields that can be configured in Member Port Settings are described below:
Parameter Description
VID
Enter the multicast VLAN’s ID that will be used here. The range is 2 to 4094.
Action
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
Role
Select the role here. Options to choose from are Receiver and Source.
• Receiver - Specifies to configure the port as a subscriber port that can only
receive multicast data in the multicast VLAN.
• Source - Specifies to configure the port as an uplink port that can send
multicast data in the multicast VLAN.
Type
Select the type here. Options to choose from are Tagged and Untagged.
• Tagged - Specifies that if a port is a tagged member, the packets sent from
the port are tagged with the Multicast VLAN ID.
• Untagged - Specifies that if the port is an untagged member, then the
packets will be forwarded in the untagged form.
Unit
Select the Switch’s unit ID that will be used here.
From Port ~ To Port
Select the Switch’s port range that will be used here.
Click the Apply button to accept the changes made.
The fields that can be configured in Replace Priority Settings are described below:
Parameter Description
VID
Enter the multicast VLAN’s ID that will be used here. The range is 2 to 4094.
Action
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
IP Type
Select the IP type here. Options to choose from are IPv4 and IPv6.
• IPv4 - Specifies to the remap priority for IPv4 multicast packets forwarded on
the multicast VLAN.
• IPv6 - Specifies to the remap priority for IPv6 multicast packets forwarded on
To Next Page
Loading...
