DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
197
Parameter Description
Interface VLAN
Enter the VLAN interface’s ID that will be associated with the IPv6 entry.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Show Detail button to view and configure more detailed settings for the IPv6 interface entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Show Detail button, the following page will be available.
Figure 6-11 IPv6 Interface (Detail, IPv6 Interface Settings) Window
The fields that can be configured are described below:
Parameter Description
IPv6 MTU
Enter the IPv6 MTU value here. The range is from 1280 to 65534 bytes. By
default, this value is 1500 bytes. This parameter is used to configure the MTU to
be advertised in RA messages.
IPv6 State
Select to enable or disable the IPv6 interface’s global state here.
Click the Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
The fields that can be configured for IPv6 Address Autoconfig are described below:
Parameter Description
State
Select to enable or disable the automatic configuration of the IPv6 address using
the stateless auto-configuration feature here. Select the Default option to specify
that if the default router is selected on this interface, a default route will be
installed using that default router. This option can be specified only on one
interface.
Click the Apply button to accept the changes made.
The fields that can be configured for Static IPv6 Address Settings are described below:
To Next Page
Loading...
