DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
209
Figure 6-28 RIP Settings Window
The fields that can be configured in RIP Global Settings are described below:
Parameter Description
RIP State
Select to globally enable or disable the Routing Information Protocol (RIP) feature
here.
Click the Apply button to accept the changes made.
The fields that can be configured in Redistribution Configuration are described below:
Parameter Description
Redistribution
First, select to enable or disable the RIP redistribution feature here.
Second, select the routing protocol (domain) that will be redistributed into RIP.
Options to choose from are Connected and Static. The Static option means to
redistribute IP static routes. The Connected option refers to routes that are
established automatically by virtue of configuring IP address on an interface.
Third, enter the value to be used as the metric for the redistributed route here.
The range is from 0 to 16.
Fourth, enter the route map’s name that is used in the filtering of the routes to be
redistributed to the current routing protocol. If not specified, all routes are
redistributed.
Click the Apply button to accept the changes made.
The fields that can be configured in RIP Configuration are described below:
Parameter Description
Update Time
Enter the update interval in seconds at which the update message is sent. The
range is from 1 to 65535 seconds. Select the Default option to use the default
value here which is 30 seconds.
Invalid Time
Enter the invalidate timer value in seconds here. The range is from 1 to 65535
To Next Page
Loading...
