DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
431
Figure 13-21 Ping Window
The fields that can be configured in Ping Access Class are described below:
Parameter Description
ACL Name
Enter the name of the ACL that will be used here. This name can be up to 32
characters long. Click the Please Select button to select an existing ACL from the
list.
Action
Select the action to be taken here. Options to choose from are Add and Clear.
Click the Apply button to accept the changes made.
The fields that can be configured in IPv4 Ping are described below:
Parameter Description
Target IPv4 Address
Select and enter an IP address to be pinged.
Domain Name
Select and enter the domain name of the system to discover.
Ping Times
Enter the number of times desired to attempt to Ping the IPv4 address configured
in this window. Users may enter a number of times between 1 and 255. Tick the
Infinite check box to keep sending ICMP Echo packets to the specified IP
address until the program is stopped.
Timeout
Select a timeout period between 1 and 99 seconds for this Ping message to reach
its destination. If the packet fails to find the IP address in this specified time, the
Ping packet will be dropped.
Frequency
Enter the frequency time for the ping here. The range is from 0 to 86400.
Source IPv4 Address
Enter the source IPv4 address. If the current Switch has more than one IP
address, you can enter one of them to this field. When entered, this IPv4 address
will be used as the packets’ source IP address sent to the remote host, or as
primary IP address.
To Next Page
Loading...
