D-Link DXS-3400 SERIES - Page 449

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
439
Log Description Severity
username: It indicates the username for authentication.
Event description: RADIUS assigned a valid priority attributes.
Log Message: RADIUS server <server-ip> assigned 802.1p default priority: <priority> to
port < interface -id> (Username: <username>)
Parameters description:
server-ip: It indicates the RADIUS server IP address.
priority: The assign priority that authorized by from RADIUS server.
interface-id: It indicates the port number of the client authenticated.
username: It indicates the username for authentication.
Informational
Event description: RADIUS assigned ACL script but fails to apply to the system due to
insufficient resource.
Log Message: RADIUS server <server-ip> assigns <username> ACL failure at port <
interface -id> (<acl-script>)
Parameters description:
server-ip: It indicates the RADIUS server IP address.
username: It indicates the username for authentication.
interface-id: It indicates the port number of the client authenticated.
acl-script: The assign ACL script that authorized by from RADIUS server.
Warning
Auto Save Config
Log Description Severity
Event description: Record the event when the configure information of DDP is saved
automatically.
Log Message:CONFIG-6-DDPSAVECONFIG: [Unit <unitID>, ]Configuration automatically
saved to flash due to configuring from DDP(Username: <username>, IP: <ipaddr>)
Parameters description:
Unit: Box ID
username: Represent current login user.
ipaddr: Represent client IP address
Informational
BPDU Protection
Log Description Severity
Event description: Record the event when the BPDU attack happened.
Log Message: <interface-id> enter STP BPDU under protection state (mode: <mode>)
Parameters description:
interface-id: Interface on which detected STP BPDU attack.
mode: BPDU Protection mode of the interface.
Mode can be drop, block, or shutdown
Informational
Event description: Record the event when the STP BPDU attack recovered.
Log Message: <interface-id> recover from BPDU under protection state.
Parameters description:
interface-id: Interface on which detected STP BPDU attack.
Informational
CFM