D-Link DXS-3400 SERIES - Page 460

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
450
Interface
Log Description Severity
Event description: Port link up.
Log Message: Port <portNum> link up, <link state>
Parameters description:
portNum: 1.Interger value;2.Represent the logic port number of the device.
link state: for ex: , 100Mbps FULL duplex
Informational
Event description: Port link down.
Log Message: Port <portNum> link down
Parameters description:
portNum: 1.Interger value;2.Represent the logic port number of the device.
Informational
IP Directed Broadcast
Log Description Severity
Event description: IP Directed-broadcast rate exceed 50 packets per second on a certain
subnet.
Log Message: IP Directed Broadcast packet rate is high on subnet. [(IP: %s)]
Parameters description:
IP: the Broadcast IP destination address.
Informational
Event description: IP Directed-broadcast rate exceed 100 packets per second
Log Message: IP Directed Broadcast rate is high.
Informational
IPSG
Log Description Severity
Event description: When there is no hardware rule resource to set DHCP Snooping entry
into IPSG table, the syslog will be record
Log Message: Failed to set IPSG entry due to no hardware rule resource. (IP: <IPADDR>,
MAC: <MACADDR>, VID: <VLANID>, Interface <INTERFACE-ID>)
Parameters description:
ipaddr: IP address
macaddr: MAC address.
vlanid: VLAN ID
interface-id: Interface name
Warning
LBD
Log Description Severity
Event Description: Loop back is detected under port-based mode.
Log Message:
Port < [unitID:] portNum> LBD loop occurred. Port blocked.
Parameters Description:
unitID: The unit ID.
portNum: The port number.
Critical