DHP-W611AV
4
ENGLISH
4. When prompted, press the Simple Connect Button for 2 seconds on the
DHP-P610AV to connect it to the DHP-W610AV.
Note: If you don’t have an existing Powerline network, you will need to
set up security for all of your existing Powerline devices. Perform the
following steps for each device: press the Simple Connect Button
on the DHP-W610AV, then press the Simple Connect Button on your
existing Powerline device within 2 minutes.
5. Follow the on-screen instructions to set up your Powerline network. For
more detailed support, please refer to the User Manual.
To Next Page
Loading...
