LIGHTING AND SIGNALS
2
126 - Getting to know your vehicle
Exterior lighting and signals
Side lights
Turn the ring
2
until the symbol
is opposite the mark
3
.
This indicator light on the instrument
panel comes on.
Note: depending on the vehicle, the
sidelightscanonlybeactivatedmanu
ally when the parking brake is applied
or, depending on the vehicle, when the
gear lever is in the P position.
Otherwise, the "Unavailable position
lights"messageisdisplayedonthein
strument panel to inform you that it is
not possible to activate the side lights.
Daytime running lights function
(front lights only)
Iffittedonthevehicle,thedaytimerun
ning lights come on automatically with
no action on stalk
1
when the engine
isstarted,andtheygooffoncetheen
gine is switched off.
Special feature:
The daytime running light will go out
automatically when the indicator light
is in operation.
Before driving at night,
check that the electrical
equipment is operating
correctly and adjust the
headlight beams (if your vehicle is
not carrying its normal load). As a
general precaution, check that the
lights are not obscured (by dirt,
mud,snoworobjectsbeingtrans
ported).
Dipped beam headlights
Turn the
2
until the symbol is
opposite mark
3
.
This indicator light on the instrument
panel comes on.
Always make sure the
windscreen is not obscured
(dirt,mud,snow,condensa
tion, etc.).
Main beam headlights
With the engine running and the
dipped beam headlights on, push the
stalk
1
.Thisindicatorlightonthein