LIGHTING AND SIGNALS
2
Getting to know your vehicle - 127
strument panel comes on.
Toreturntothedippedbeamhead
lights position, pull the stalk
1
towards
you again.
Automatic main beam headlights
Depending on the vehicle, this
systemswitchesthemainbeamhead
lights on and off automatically.
Itusesacameralocatedbehindthein
teriorrearviewmirrortodetectvehi
cles that are being followed and those
coming in the opposite direction.
Note: at night, in urban areas with
street lighting, the automatic main
beam headlights automatically switch
off.
The main beam headlights come on
automatically if:
– the exterior light level is low;
– noothervehicleorlightingisdetect
ed;
– thevehiclespeedisaboveapproxi
mately 25 mph (40 km/h).
If any of the above conditions are not
fulfilled, the system switches to dipped
beam headlights.
Note: make sure that the windscreen
isnotobscured(dirt,mud,snow,con
densation, etc.).
To activate the automatic main
beam headlights
Turn ring
2
until the AUTO symbol is
aligned with the mark
3
.
The indicator light ontheinstru
ment panel lights up if the dipped
beam headlights are on.
To deactivate the automatic main
beam headlights
Turn ring
2
, until the symbol is
opposite mark
3
. The warning light
willdisappearfromtheinstru
mentpanelandthemainbeamhead
lights will be activated.
The system may encounter
difficulties under certain
conditions, including:
– extreme weather conditions
(rain, snow, fog, etc.);
– obstructioninfrontofthewind
screen or camera;
– when a following or oncoming
vehiclehasweakorhiddenlight
ing;
– incorrect settings for the front
headlights;
– reflecting systems;
– ...
Operating faults
When the "Check Automatic Lighting"
message appears on the instrument
panel, the system is deactivated.
Consult an approved Dealer.
Switching off the dipped beam
headlights
There are two possibilities: