Dacia DUSTER 2024 - Headlight Beam Adjustment

LIGHTING AND SIGNALS
2
Getting to know your vehicle - 129
Oncethefunctionisactivated,theday
time running lights and the rear side
lightslightupautomaticallyondetect
ingthecardorwhenthevehicleisun
locked and a beep sounds.
They switch off automatically:
– approximatelyoneminuteafterlight
ing up;
– when starting the engine, based on
the position of the lighting stalk;
or
– upon locking the vehicle.
Activating/deactivating the function
To activate or deactivate the external
welcomefunction,pleaseseethemul
timedia instructions.
Choose "ON" or "OFF".
Lights-on reminder audible alarm
A warning beep sounds when the
driver's door is opened to warn you
that the lights are still on.
Before driving at night,
check that the electrical
equipment is operating
correctly and adjust the
headlight beams (if your vehicle is
not carrying its normal load). As a
general precaution, check that the
lights are not obscured (by dirt,
mud,snoworobjectsbeingtrans
ported).
Headlight beam adjustment
Switch A is used to adjust the height
of the headlight beams according to
the load.
With the dipped beam headlights on,
press or raise switch A as many times
asrequiredtoselecttherequiredposi
tion on the instrument panel.
The position selected is displayed on
the instrument panel for approximately
30 seconds.
Note: depending on the vehicle, each
timetheignitionisswitchedon,thepo
sitionselectedisdisplayedonthein
strument panel for approximately 30
secondsandforapproximately5sec
onds each time switch A is pressed.