PARKING BRAKE
3
Driving - 171
Beforeleavingthevehi
cle,checkthattheelec
tronic parking brake is
fully applied. Warning
light
3
on switch
4
and warning
light ontheinstrumentpan
el illuminate to show that the
parking brake is applied but
switch off when the doors are
locked.
Brief stop
To apply the electronic parking brake
manually (when stopping at a red light,
stopping when the engine is running,
etc.): pull and release the switch
4
.
The brake is released as soon as the
vehicle is started up again.
Special cases
To park on a slope or while towing a
trailer, for example, pull switch
4
for a
fewsecondstoenablemaximumbrak
ing.
To park, with the electronic parking
brake released (if there is a risk of
freezing, for example):
– engage any gear or the P position:
the drive wheels will be mechanically
locked by the driveshaft;
– switch off the engine by pressing the
engine start/stop button
1
or by turning
the ignition key
2
;
– unfasten the driver's seat belt;
– open the driver's door;
– manuallyreleasetheelectronicpark
ing brake (please see the paragraph
on "Manually releasing the electronic
parking brake");
– dependingonthevehicle,theelec
tronicparkingbrakeisappliedauto
matically. You will have to release it
manually;
– close the driver's door and lock the
vehicle.
Versionswithanautomaticgear
box
For safety reasons, automatic release
isdeactivatedwhenthedriver’sdooris
openornotshutproperlyandtheen
gine is running (in order to prevent the
vehiclefrommovingwithoutthedri
ver). The "Release Parking Brake"
message appears on the instrument
panelwhenthedriverpressestheac
celerator pedal.