EasyManua.ls Logo

Dacia DUSTER 2024 - Page 186

Dacia DUSTER 2024
406 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TYRE PRESSURE LOSS WARNING
3
184 - Driving
thesystemmustberesetwithaninfla
tion pressure equal to one of those
shownonthetyreinflationpressurela
bel (reference values) 🡺327.
Resetting should always be carried
out after checking the tyre pressure
of all four tyres when cold.
In the following situations, the system
riskcomingintoactionlateornotfunc
tioning correctly:
system not reset after reinflation or
any operation on the wheels;
incorrectlyresetsystem:tyrepres
sures different from the recommended
pressures;
The tyre pressure must be
checked before starting the
resetting procedure.
Thesystemwillnotissueawarn
ingifthepressuredoesnotcorre
spondtotherecommendedpres
sure.
significantchangeinloadordistribu
tion of load on one side of the vehicle;
sportydrivingwithstrongaccelera
tion;
driving on snowy or slippery surface;
driving with snow chains;
fitting a single new tyre;
useoftyresnotapprovedbythenet
work.
Thesuddenlossofpres
sure in a tyre (burst tyre,
etc.) cannot be detected by
the system.
Procedure for resetting the standard
levels for the tyre pressures
This should be performed:
after each re-inflation or resetting of
tyre pressure;
after changing a wheel;
after swapping a wheel (however,
this practice is not recommended);
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving,
etc.).Respectthetyrepressures(in
cluding the emergency spare wheel).
Check them at least once a month and
before a long journey (refer to the label
ontheedgeofthedriversdoor
🡺327).
Vehicle not fitted with a multimedia
screen
Ignition on, vehicle stopped:
on vehicles equipped with a type
A
or
B
🡺98 instrument panel, press
switch
3
as many times as necessary
to reach the "VEHICLE" tab;
briefly press switch
4
or
5
to reach
the "Tyre pressure init. long press"
page;
press and hold the
6
"OK" switch to
launch the reset.
Hold down the
6
switchuntilthe"Op
eration completed" message appears.
You can now drive.
Vehicles fitted with a multimedia
screen

Table of Contents

Related product manuals