Dacia DUSTER 2024 - Activating Cruise Control

CRUISE CONTROL
3
238 - Driving
Activating cruise control
While the vehicle is moving a steady
speed above approximately 19 mph
(30 km/h), press switch 6 ( SET/˗ ) or
switch 1 ( SET/+ ):thefunctionisacti
vated and the current speed is taken
into account.
Thecruisingspeedreplacesthedash
es. Cruise control is confirmed when
the memorised speed and warning
light appear in green 7 .
If you try to activate the function below
19mph(30km/h),themessage"In
valid Speed" will be displayed and the
function will remain inactive.
Driving
Once a cruising speed is registered
andthecruisecontrolfunctionisac
tive,youmayliftyourfootofftheaccel
erator pedal.
Please note that you
must keep your feet
closetothepedalsinor
dertoreactinanemer
gency.
Adjusting the cruising speed
The cruising speed may be changed
by repeatedly pressing the:
– switch 6 ( SET/˗ ) to decrease the
speed;
– switch 1 ( SET/+ ) to increase the
speed.
Note: press and hold one of the
switchestomodifyspeedbysucces
sive increments
Exceeding the cruising speed
The cruising speed may be exceeded
atanytimebydepressingtheacceler
ator pedal.
While it is being exceeded, the cruising
speed flashes on the instrument panel.
Then, release the accelerator pedal:
after a few seconds, the vehicle will
automatically return to its set cruising
speed.
If the cruise control is no
longer available (after
severalattemptstoacti
vateit),contactanAp
proved Dealer.
Putting the function on standby
The function is set to standby if you:
– the switch 4 (O);
– the brake pedal;