STOP AND GO ADAPTIVE CRUISE CONTROL
3
250 - Driving
Warning
Thisfunctionisanadditionaldrivingaid.Itcanundernocircumstancesreplacethedriver'sresponsibilitytore
spect speed limits and safe distances or to be vigilant.
The driver must always be in control of the vehicle.
Thedrivermustalwaysadapttheirspeedtothesurroundingsanddrivingconditions,regardlessofsystemindica
tions. Except for lines delimiting lanes, traffic indicators (traffic lights, signs, pedestrian crossings etc.) are not recognised
by the system. These do not trigger any alert or reaction by the system.
The system should under no circumstances be taken to be an obstacle detector or an anti-collision system.
The adaptive cruise control must only be used on a motorway (or multi-lane road separated by a barrier).
System servicing/repairs
– Intheeventofanimpact,thecameraalignmentmaybechangedanditsoperationmayconsequentlybeaffected.Deac
tivate the system and consult an authorised dealer.
– Any work in the area where the camera is located (repairs, replacements, windscreen modifications etc.) must be carried
out by a qualified professional.
Only an authorised dealer is qualified to service the system.
Deactivating the function
You must deactivate the function if:
– the vehicle is travelling on a winding road;
– the vehicle is being towed (breakdowns);
– the vehicle is towing a trailer or a caravan;
– the vehicle arrives at a toll point, a roadwork area or on a narrow lane;
– the vehicle is being driven up or down a very steep slope;
– the visibility is poor (glaring sun, fog, etc.);
– the vehicle is being driven on a slippery road surface (rain, snow, gravel, etc.);
– the weather conditions are poor (rain, snow, side winds, etc.);
– the camera area has been damaged (e.g. on the inside or outside of the windscreen);
– the windscreen is cracked or distorted.