Dacia DUSTER 2024 - Page 307

TRANSPORTING OBJECTS
4
Your comfort - 305
– tighten the bolts 2 as far as possible
using the tool 6 until markers D and E
located on the tool 6 are parallel (mark
8 );
– re-clip the rotary covers 1 .
Note: bars 3 and 4 arenotinter
changeable.
It is strictly forbidden to
place the roof bars in the
transverseposition(car
ryingposition)whenen
tering a roller-type car wash.
Make sure that the two
modular roof bars are
correctly position and
locked.
Roof bars in the trans
verse position
– The maximum speed
must be limited to 80 mph (130
km/h).
– During the journey, check the
installation and tighten the bolts
every 300 miles (500 km) or so.
When not using the bars in
transverse position, refit the
bars in longitudinal position
inordertooptimisefuelconsump
tion and avoid air noise.
If lost, contact an approved
dealer to obtain the bolts 2
and the tool 6 .
The modular roof bars
are originally assembled
and approved by our
Technical Department.
They are provided together with
the bolts 2 and the tool 6 . These
must only be used for attaching
the roof bars to the vehicle.
Regularly check the condition of
themodularroofbars(correctpo
sitioning of the bars, mounting
points, bolts, etc.).
Donotusethemiftheyaredam
aged.ContactanapprovedDeal
er.
Check that the objects
and/or accessories (bike
rack, roof box etc.) fitted
to the modular roof bars
are correctly positioned, evenly
distributed and secured.