HEADLIGHTS, LIGHTS: REPLACING BULBS
6
350 - Practical advice
– Unscrewthescrewusingascrew
driver;
– access the bulb holder by unclipping
the flap
4
;
– turn the bulb holder by a quarter of a
turn;
– remove the bulb.
Bulb type: H16.
The bulbs are under
pressure and may break
when replaced.
Risk of injury.
Refitting
To refit, proceed in the reverse order,
taking care not to damage the wiring.
Once the bulb has been replaced,
check that it is properly secured.
However, we would advise you to
have these bulbs replaced by an Ap
proved Dealer.
Tocomplywithlocallegisla
tion, or as a precaution, you
can obtain an emergency
kit containing a set of spare bulbs
andfusesfromanapproveddeal
er.
Pleasenotewhenwork
ing close to the engine
that it may be hot. The
engine cooling fan may
also start at any moment. The
labelintheenginecom
partment reminds you of this.
Risk of injury.
Rear fog light
5
(depending on the vehicle)
Access the bulb holder located under
the rear bumper, then unscrew it by
turningtowardsthecentreofthevehi
cle and remove the bulb.
Bulb type: P21W.
Donottouchtheex
haust.
Risk of burns.
Refitting
To refit, proceed in the reverse order,
taking care not to damage the wiring.
Once the bulb has been replaced,
check that it is properly secured.
However,becauseoftheirreducedac
cessibility, we advise you to have
your bulbs replaced by an approved
Dealer.
The bulbs are under
pressure and may break
when replaced.
Risk of injury.