WIPER
2
menu, you can opt to activate or deac-
tivate this function 🡺106.
For vehicles not fitted with a settings
customisation menu, you can have this
function deactivated by an authorised
dealer.
If obstacles are present on the rear
window (dirt, snow, etc.), the wiper will
try to sweep away all the obstacles. If
an obstacle prevents the blade from
moving, it can be stopped. Remove
the obstacle, wait for around 30 sec-
onds and reactivate the wiper using
the wiper stalk.
Precautions
– If the weather is icy, check that the
blade is not stuck to the windscreen
before operating the wipers. If you acti-
vate the wiper while the blade is
blocked by ice, you risk damaging both
the blade and the wiping motor.
– Do not operate the wipers on a dry
screen as this will cause premature
wear or damage to the blades.
Rear screen wash/wipe
With the ignition on, push and
hold the stalk
1
then release it.
Holding the stalk for longer will trigger
(in addition to the windscreen washer)
two sweeps of the rear wiper followed,
a few seconds later, by a third (drip
wiping function).
When the stalk is released, it returns to
the rear screen wiper position.
130 - Getting to know your vehicle
To Next Page
Loading...
