TYRE PRESSURE MONITORING SYSTEM
3
Possible tyre pressure faults
Indicator lights Messages
(depending
on the vehi-
cle)
Displays
(depending on the
vehicle)
Readings
comes on (not
flashing).
Adjust Tyre
Pressure
The wheel and associated pressure value are displayed in yel-
low.
This indicates that tyre under-inflation has been detected. Check
and adjust the pressure of the four tyres then reset the system.
+
comes on (not flash-
ing).
Puncture
The wheel and associated pressure value are displayed in red.
This indicates that the tyre concerned is punctured or severely
underinflated. Adjust the pressure of the four tyres while cold and
reset the system if the tyre is deflated. Replace the tyre (or have
it replaced) if it is punctured.
flashes, then
stays on, along with
the warning light
Check Tyre
Pressure
Sensors
A wheel is no longer displayed.
This indicates that at least one wheel is not fitted with a sensor
(e.g. emergency spare wheel) or that the sensor is faulty. Consult
an approved Dealer.
comes on (not
flashing).
Failure to de-
tect tyres
This indicates that the system has not been able to determine
the pressure of each tyre. This may be caused by the use of a
sensor not recommended by an approved dealer. The tyre pres-
sure sensor monitoring system remains in operation.
174 - Driving
To Next Page
Loading...
